9
9.2 CD-ROM/Tape Drive
9.2.1 Removing the Bracket from the Chassis
9-6
1. Remove the two screws from the chassis that secure the drive bracket.
See Figure 9-5.
Clip
Figure 9-5
Drive Bracket
2. Remove the DC harness from the clip located on the drive bracket.
See Figure 9-5.
3. Disconnect the DC harness from the peripheral power cable at P1.
4. Push the drive bracket toward the disk drive bay, and gently flip it over.
Place it on top of the disk drive bay.
See Figure 9-6.
Sun Ultra 1 Series Service Manual—November 1995
P1
DC harness
Screws