Syscom Video MR3000C User Manual page 85

STEP 7. Connection to the SCS
The SCS (Syscom Cloud Software) is the cloud software provided by Bartec Syscom for the
management and the visualization of the data coming from the MR3000 instruments.
The connection to the SCS is fundamental:
to visualize and process all the data
•
to remotely control the units
•
To configure the connection MR3000-SCS, access the section System / SCS cloud on the Web
User Interface and then insert the token generated by the SCS. Once the unit is connected to the
cloud, select the time interval between two successive synchronizations between the MR3000 and
the SCS. Refer to chapter 4.3.10 for more details.
For more information about the SCS and the creation of a new account, please visit the
website or the dedicated
STEP 8. Installation at site
You should choose a convenient place where an AC power plug is available (in case of a long
monitoring) and with a reasonably good GSM/UMTS coverage. The sensor must be installed in a
perfect horizontal or vertical position, depending on the sensor that has been purchased (Section
2.5.5 for more details).
Once the unit is started up make a final check with your smartphone/tablet/PC before leaving the
place. In particular, the page relative to the Status (see chapter 4.2) gives many useful information.
Finally, it it is possible to open the page relative to the Status (see chapter 4.2) to check:
MR3000CMR3000C_TR_v2.0_rev1.odt
webpage on the Bartec Syscom website.
Figure 5.1.7. Settings of the connection MR3000-SCS.
subject to technical change without notice
SCS
85