Syscom Video MR3000C User Manual page 84

In the example, the limits of alarm 1 have been set based on the German norm DIN 4150-3, at 90%
of its values. This means that the real values are reduced by 10% to create a warning threshold.
The limits of alarm 2 have been set to user-defined values.
STEP 6. Notifications
NOTE: This step is useful only in case the MR3000 has an internet connection.
• Insert the contacts concerned in the monitoring
• Select the information that each contact should receive
In particular, let us suppose that you want to send an SMS to the site supervisor if the vibration
level exceeds the alarm thresholds. Moreover, we add a new contact called Operator, that will be
informed about every specific notification on the system. More details can be found in chapter
4.4.4.
In particular, in case a message should be sent to site supervisor if vibration level is exceeding the
alarm threshold, then a dedicated contact can be created in the WebUI (Figure 5.1.6 on the left),
while other contacts with other kinds of messages can be created, for example for an operator
(Figure 5.1.6 on the right).
Figure 5.1.6. Settings of the contact.
84
MR3000CMR3000C_TR_v2.0_rev1.odt subject to technical change without notice