Table of Contents
Advertisement
2.5.2
SD card
The MR3000 contains an SD card slot. The SD Flashcard in this slot is used to store the
recordings. The SD card used is a Swissbit industrial SD card. To remove the card, you have to
push it down, it will then pop up.
NOTE: Ensure the MR is turned off before removing and re-inserting the SD Flashcard.
Inserting the SD Card in the card-reader of your PC allows you a fast access to all the data of the
MR3000. If you have copied all the data, you can format the SD Card.
2.5.3
Internal backup-battery
The MR is equipped with a real-time clock with back-up lithium battery. Even if the MR is switched
off, the clock continues working.
The lithium battery is located on the main board (at the lower right end). Replacement by the user
is possible without any special tools.
MR3000CMR3000C_TR_v2.0_rev1.odt
Figure 2.5.2.Removing the SD Flashcard from the MR.
subject to technical change without notice
15
Advertisement
Table of Contents
Need help?
Do you have a question about the MR3000C and is the answer not in the manual?