Table of Contents
Advertisement
Adjustment configuration values are shown on the front panel LCD screen, or on
the control device display if using RS-232 or Ethernet to make adjustments.
N Invalid picture adjustments for any input/output combination shows N/A
N For making adjustments via RS-232/RS-422, see
For front panel adjustments follow the sections below.
Adjusting the picture color/tint
To adjust the picture color/tint do the following:
1.
2.
N All applicable outputs light or flash green. To change to a different output, press
Step 1.
Press the Esc button to
clear all selections.
C O N T R O L
ENTER
PRESET
VIEW
ESC
The Esc button flashes
green once.
N The LCD shows the current Color/Tint setting.
Figure 3-33 — Steps 1 and 2 for adjusting color and tint
3.
N If video or YC inputs are not an NTSC signal, the tint value is "N/A".
4.
Adjusting the picture brightness/contrast
To adjust the picture brightness/contrast do the following:
1.
2.
N All applicable outputs light or flash green. To change to a different output, press
ISM 824 Integration Scaling Multiswitcher • Operation and Setup
instead of the configuration values.
and Control"
for methods and commands. For Windows Control Program, see
chapter 5 " ISM 824 Multiswitcher
commands, see
chapter 6, "HTML
Press the Esc button to clear all pending changes and reset the LCD.
Press and release the Color/Tint adjustment button. The output buttons for
scaler/scan converter cards (outputs 3 through 8) and any associated (tied)
input button light solid green. Untied outputs flash green. The LCD panel
shows the current color/tint setting (see figure 3-33) for that lit output.
the desired output button. The selected button lights green.
Step 2.
Press the Color/Tint button.
The button lights green.
COLOR/
BRIGHT/
DETAIL
POSITION
SIZE
TINT
CONT
PICTURE ADJUSTMENTS
Col Out #5 Tint
128
128
Using the left front panel encoder (
128), and with the right (
Press the Esc button to clear all button and reset the LCD.
Press the Esc button to clear all pending changes and reset the LCD.
Press and release the Bright/Cont adjustment button. The output buttons for
scaler cards (outputs 3 through 8) and any associated (tied) input buttons light
solid green. Untied outputs flash green. The LCD panel shows the current
bright/cont setting (see figure 3-34) for that lit output.
the desired output button. The selected button lights green.
chapter 4, "SIS
Software", and for Ethernet methods and
Operation".
1
2
3
ZOOM
1
2
3
The applicable output card button (#5) and associated
input (#2) light green. Non tied outputs (#8) flash green.
[
adjust the color (0 to 255, default is
),
{
) encoder, adjust the tint (0 to 255, default is 128).
Programming
™
INPUTS
4
5
6
7
8
4
5
6
7
8
OUTPUTS
3-23
Advertisement
Table of Contents
