Extron electronics ISM 824 User Manual page 32

Installation, cont'd
N If the device does not recognize a newly installed card, power the unit down,
8.
9.
10.
2-10 ISM 824 Integration Scaling Multiswitcher • Installation
remove the card and re-install, closely following steps 4 through 7 above.
If it continues to not recognize the card, contact Extron HelpLine (see rear
cover).
Connect output devices to the video and audio connectors on the rear of the
newly installed cards and power up the devices.
Power up the input devices and create the desired ties, following the steps
given in chapter 3, "Operation and
Configure the ISM 824 with the new cards, following the steps given in
chapter 3, "Operation and
Control", chapter 5, "ISM 824 Multiswitcher
Operation", for alternative methods in configuring the multiswitcher.
Setup".
Setup". Also see chapter 4, "SIS Programming and
Software", and chapter 6, "HTML