Select Output Submenu; Output Config Submenu - Extron electronics ISM 824 User Manual

Operation and Setup, cont'd

Select Output submenu

This menu allows selection of any configurable Video Scaler outputs installed to
be configured using further submenus. To select an output to configure, do the
following:
1.
2.
3.

Output Config submenu

Within this submenu, the resolution, the refresh rate, the output signal type, and
the sync polarity can be selected and adjusted.
1.
2.
N There are 19 output resolutions to choose from (640 x 480 at 50 Hz through
Figure 3-49 — Video Scaler output resolution/refresh rate table
3.
3-38 ISM 824 Integration Scaling Multiswitcher • Operation and Setup
From the top level (Output Card Configuration) menu, press Next to enter
the first submenu level (Select Output). The last selected scaler card output
button and its associated input button lights green, and the LCD indicates the
selected output.
If configuration of another output is desired, press that output button to select
it. The LCD shows the new selection, and the corresponding buttons light.
Proceed to the rest of the submenus to configure the selected output.
From the Output Config. submenu press Menu.
Press Next to bring up the Resolution submenu. In this submenu, the
resolution and refresh rate can be adjusted.
1080p at 60 Hz). The refresh rate is dependant on the resolution selected.
See the resolution/refresh rate table below.
Resolution 50 Hz
640x480 X
800x600 X
852x480 X
1024x768 X
1024x852
1024x1024
1280x768 X
1280x1024 X
1360x765 X
1365x768 X
1366x768 X
1365x1024 X
1400x1050 X
1600x1200
480p
576p X
720p X
1080i X
1080p X
Rotate the left front panel encoder (
{
rotate the right encoder (
Press Next for the next submenu, Output Type. Within this submenu the
output signal type (RGBHV, RGBS, RGsB, YUV Bi-Level) can be selected.
Rotate either front panel encoder to select the output signal type .
60 Hz 72 Hz 96 Hz
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
[
) to adjust the resolution value, and
) to adjust the refresh rate.
100 Hz 120 Hz