Installing Cover - MacDon R113 Assembly Instruction Manual

ASSEMBLING THE ROTARY DISC PULL-TYPE – FACTORY-INSTALLED TRANSPORT
NOTE:
If connections are reversed, the lamp will not illuminate when
the toggle switch is in field mode. Try the following to correct
the issue:
• Check if 10 amp fuse (A) located inside the transport control
box has blown.
• Check for short in wires to solenoid valve on header.
• Check for incorrect wire connections (reversed) at the power
supply or solenoid valve.
6. Place the remote control inside the tractor cab.

4.8.5 Installing Cover

The transport cover protects the hydraulic valves and electrical components from debris.
1. Install cover (A) onto the cover support.
2. Install bolts (B). Torque bolts to 60 Nm (45 lbf·ft).
215585
Figure 4.83: Control Box Interior
Figure 4.84: Cover
96
Revision A