Transport; Repositioning Center-Link Top Anchor - MacDon R113 Assembly Instruction Manual

Chapter 3: Assembling the Rotary Disc Pull-Type – With or
Without the Dealer-Installed Transport
Perform the following procedures in the order provided to assemble the rotary disc pull-type without the transport system,
or when the transport will be installed by the Dealer.
To assemble a rotary disc pull-type with the factory-installed transport, refer to
Factory-Installed Transport, page

3.1 Repositioning Center-Link Top Anchor

Perform this procedure to reposition the center-link top anchor into working position.
1. Place forklift forks (B) under top beam and lift carrier
frame (A) slightly until pin at base of center-link anchor is
loose. Use piece of wood (C) to protect paint on frame.
2. Loosen retaining bolt (A) and rotate cover plate (B) away
from float spring bolt (C). Repeat on opposite side.
3. Fully loosen float spring bolt (C). Repeat on opposite side.
215585
61.
4 Assembling the Rotary Disc Pull-Type –
Figure 3.1: Carrier
Figure 3.2: Float Spring – Right Side
9
Revision A