Attaching Hitch To Carrier - MacDon R113 Assembly Instruction Manual

ASSEMBLING THE ROTARY DISC PULL-TYPE – FACTORY-INSTALLED TRANSPORT

4.2 Attaching Hitch to Carrier

The connection point on the carrier frame secures the hitch to the frame and allows the pull-type to pivot.
1. Remove cam assembly (A) from shipping support (B) by
loosening nuts (C) and sliding the cam assembly off of the
shipping support.
2. Rest the cam assembly on the carrier hydraulics.
3. Remove and discard bolts (A) and shipping support (B).
NOTE:
You may need to pry up the shipping support to remove
the hardware.
4. Remove six M20 bolts (A), washers, and nuts from carrier at
the hitch attachment location. Retain bolts, washers,
and nuts.
215585
Figure 4.11: Alignment Controls – Front Right View
Figure 4.12: Shipping Support – Front Right View
Figure 4.13: Carrier Frame
65
Revision A