Installing Remote Control - MacDon R113 Assembly Instruction Manual

ASSEMBLING THE ROTARY DISC PULL-TYPE – FACTORY-INSTALLED TRANSPORT

Installing Remote Control

The remote control allows the operator to convert the pull-type from field to road mode from the within the tractor cab.
1. Retrieve remote control (A) with wiring harness.
2. Place remote control (A) on hitch temporarily.
3. Locate connector (C) that branches off seven-pole transport
plug (A) and attach it to remote wiring harness (B).
4. If your tractor has a three-pin auxiliary power connection:
NOTE:
The remote control has internal protection which prevents
damage caused by incorrect wiring, short circuits, or
overload conditions.
Connect two wires (B) from three-pin auxiliary
connector (A) to remote control wires (C) on the remote
control, wrap connections with electrical tape, and proceed
to Step 6, page 96.
• The wire with no tag connects to the tractor ground.
• The wire with the red tag connects to the tractor power.
215585
Figure 4.78: Remote Control on Top of Hitch
Figure 4.79: Transport Harness
Figure 4.80: Three-Pin Auxiliary Connector
94
Revision A