Connecting Hydraulics - MacDon R113 Assembly Instruction Manual

5.3.3 Connecting Hydraulics

Hydraulic hoses and lines distribute hydraulic fluid to the various components on the pull-type.
WARNING
Do NOT use remote hydraulic system pressures over 20,684 kPa (3000 psi). Check your tractor operator's manual for
remote system pressure.
NOTE:
Refer to the numbered/colored bands on the hoses to identify lift, swing/transport, and tilt hose sets.
Table 5.3 Hydraulic System Hoses
System
Hose Identification
Red #1 - pressure
Lift (A) Blue #1 - return (only
with transport installed)
Swing/ Red #2 - pressure
Transport (B) Blue #2 - return
Red #3 - pressure
2
Tilt (C)
Blue #3 - return
1. Connect the lift cylinder hose (red collar with #1) to the
tractor's hydraulic receptacle. Connect the second hose
(blue collar with #1) only when the transport is installed.
Refer to Table 5.4, page 106
functioning correctly.
2. Connect the two hitch swing cylinder hoses (collars with #2)
to the tractor hydraulic receptacles. Refer to Table
page 106 to confirm the system is functioning correctly.
3. For machines with hydraulic center-link only, connect the
two tilt cylinder hoses (collars with #3) to the tractor
hydraulic receptacles. Refer to Table
confirm the system is functioning correctly.
2. Available with hydraulic tilt option installed.
215585
CONNECTING THE TRACTOR TO THE ROTARY DISC PULL-TYPE
Tractor
Hydraulics
Control 1
Control 2
Control 3
to confirm the system is
5.5,
5.6, page 106 to
Figure 5.15: Hydraulic Connections
Table 5.4 Lift System
Control Lever
Position
Forward
Backward
Table 5.5 Hitch Swing and Transport System
Control Lever
Position
Forward
Backward
Table 5.6 Tilt System
Control Lever
Position
Forward
Backward
106
Rotary Disc
Cylinder
Pull-Type
Movement
Movement
Retract Lower
Raise
Extend
Rotary Disc
Cylinder
Pull-Type
Movement
Direction
Extend Right
Retract
Left
Rotary Disc
Cylinder
Pull-Type
Movement
Movement
Retract Lower
Extend Raise
Revision A