Attaching Clutch Driveline - MacDon R113 Assembly Instruction Manual

ASSEMBLING THE ROTARY DISC PULL-TYPE – WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT

3.5 Attaching Clutch Driveline

The clutch driveline on the carrier hitch, connects to the rotary disc pull-type drive gearbox.
IMPORTANT:
If a conditioner swap is required before delivery to the customer, swap the conditioner BEFORE attaching the clutch
driveline. For conditioner swap instructions, refer to the pull-type technical manual. After swapping the conditioner, attach
the clutch driveline then follow the remaining chapters in this manual in sequential order to complete the setup.
1. Support driveline (B) and remove strapping (A) securing it
to hitch. Remove all packing material.
2. Remove strapping (A) and packing material securing
steering arm (B) to hitch. Pivot steering arm to the side
for now.
NOTE:
Strapped contents may be under pressure.
3. At the top of the upper rear swivel gearbox, remove two
bolts (A) with washers (B) and spacers (C). Retain hardware.
4. Undo latches (D) securing driveline shield (E) to the upper
rear swivel gearbox and remove the shield. If necessary, use
a screwdriver or equivalent to undo latches (D).
5. Rotate the upper rear swivel gearbox until the input shaft is
facing towards the driveline.
215585
Figure 3.47: Driveline Strapping
Figure 3.48: Steering Arm Strapping
Figure 3.49: Driveline Shield
28
Revision A