Chapter 4: Assembling The Rotary Disc Pull-Type - Factory-Installed Transport; Repositioning Center-Link Top Anchor - MacDon R113 Assembly Instruction Manual

Chapter 4: Assembling the Rotary Disc Pull-Type – Factory-
Installed Transport
Perform the following procedures in order when assembling a rotary disc pull-type with a factory-installed transport.

4.1 Repositioning Center-Link Top Anchor

The center-link top anchor must be repositioned into working position.
1. Cut straps (C) securing transport assembly (A) to pallet (B).
2. For rotary disc pull-types with finger conditioners only:
Remove bolt (A) securing center shield (B) to the frame.
Lower the shield.
215585
Figure 4.1: Transport Assembly
Figure 4.2: Center Shield – Finger Conditioners Only
61
Revision A