Chapter 6: Completing Rotary Disc Pull-Type Assembly; Installing Field Wheels - MacDon R113 Assembly Instruction Manual

Chapter 6: Completing Rotary Disc Pull-Type Assembly

6.1 Installing Field Wheels

The pull-type rolls on the field wheels when in the field position. When transport is deployed (if equipped), field wheels are
raised off the road.
1. Remove shipping strap (B) from wheel spindle (A). Repeat
on opposite side.
2. Remove wheel bolts (A) from spindle (B).
CAUTION
When installing wheel, be sure to match countersunk holes
with bolt head profiles. Holes that are not countersunk do NOT
correctly seat the bolts.
3. Position wheel (A) on the spindle, install bolts (B), and
partially tighten.
IMPORTANT:
Be sure valve stem (C) points away from the wheel support.
NOTE:
Field wheels must be installed inboard on carrier frame.
215585
Figure 6.1: Wheel Spindle
Figure 6.2: Wheel Spindle
Figure 6.3: Installing Wheel Bolts
109
Revision A