Attaching Rotary Disc Pull-Type To The Tractor; Attaching With Drawbar Hitch - MacDon R113 Assembly Instruction Manual

5.3 Attaching Rotary Disc Pull-Type to the Tractor

Refer to the attachment procedure that applies to your tractor:
•
5.3.1 Attaching with Drawbar Hitch, page 101
•
5.3.2 Attaching with Two-Point Hitch, page 103

5.3.1 Attaching with Drawbar Hitch

If the pull-type was configured for a tractor with a drawbar hitch, and the tractor's hitch has been adjusted correctly, then
the pull-type can now be attached to the tractor.
DANGER
To avoid bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key before making adjustments to the machine.
1. Shut down the engine, and remove the key from
the ignition.
2. Remove lynch pin (A) from clevis pin (B), and remove the
clevis pin from the rotary disc pull-type hitch.
DANGER
Never start or move the machine until you are sure all
bystanders have cleared the area.
3. Move the tractor to position drawbar hitch adapter (A)
under pin (B) in the hitch. Adjust height as necessary
with jack.
215585
CONNECTING THE TRACTOR TO THE ROTARY DISC PULL-TYPE
Figure 5.3: Rotary Disc Pull-Type Hitch
Figure 5.4: Rotary Disc Pull-Type Hitch
101
Revision A