Installing Tractor Mating Hitch To Carrier Hitch; Installing Drawbar Hitch - MacDon R113 Assembly Instruction Manual

ASSEMBLING THE ROTARY DISC PULL-TYPE – FACTORY-INSTALLED TRANSPORT

4.3 Installing Tractor Mating Hitch to Carrier Hitch

The tractor mating hitch connects the carrier hitch to the style of hitch on the tractor.
Depending on rotary disc pull-type configuration, refer to the applicable installation procedure:
•
4.3.1 Installing Drawbar Hitch, page 69
•
4.3.2 Installing Two-Point Hitch (Cat. II) Adapter, page 74

4.3.1 Installing Drawbar Hitch

The drawbar swivel hitch allows the pull-type to connect to a single point hitch connection and swing behind the tractor
without sacrificing turning range.
1. Remove shipping wire or banding (A) securing shipping
blocks (B) at front of hitch, and remove blocks.
2. Swivel lower gearbox until the input shaft is facing forward.
3. Remove shipping wire (A) from jack (B), toolbox (C), and
jack stand support (D).
4. Remove jack (B), toolbox (C), and jack stand support (D)
from the pallet. Leave drawbar hitch (E) attached to the
pallet.
5. Remove the hardware bag from the jack stand support.
215585
Figure 4.22: Hitch End Packing
Figure 4.23: Jack and Drawbar Hitch Packing
69
Revision A