Table of Contents
Advertisement
Configuration Quick Guide
6.2
Setup New Configuration
Follow these steps to setup a new Communicator configuration.
1. Subnetwork configuration
On the Communication page:
a.
Select a serial protocol:
–
Modbus RTU (default)
–
Custom Request/Response
–
Custom Produce/Consume
For information about the serial
protocol types, refer to
Protocol Types, p.
b.
Configure the basic settings Physical
standard, Baud rate, Data bits, Parity
and Stop bits.
2. Create Transaction Templates
This step applies when the serial protocol
Custom Request/Response or Custom
Produce/Consume is selected.
On the Transaction templates page: Add
a transaction template for each way
information can be requested/received or
produced/consumed.
Repeat until you have added and
configured all your transaction templates.
3. Add Nodes and Transactions
On the Nodes & transactions page:
a.
Add a node and configure the Node
settings.
b.
Add transactions to request/receive
data or produce/consume data and
configure the transaction settings.
Repeat until you have added and
configured all your nodes.
®
™
Anybus
Communicator
User Manual
Serial
9.
26 (124)
SCM-1202-162 1.1 en-US
Advertisement
Table of Contents
