Table of Contents
Advertisement
Communicator Configuration
7.10
I/O Data Map
On the I/O data map page the data communication between the subnetwork (Node) and the
high level network (PLC) is mapped.
For more information about addressing and register mapping, refer to
Mapping, p.
The allocated I/O area is auto-generated based on how the settings on the Serial communication
page and the Nodes and transactions page are configured.
It is possible to set the I/O area manually, if you want to pro-actively allocate more I/O for future
expansions without re-configuring the PLC. Refer to
There are three areas: Data from Modbus TCP, Data to Modbus TCP and General Areas. Refer to
Map Area, p.
®
™
Anybus
Communicator
User Manual
84.
74.
Addressing and Register
To Configure I/O Sizes Manually, p.
SCM-1202-162 1.1 en-US
71 (124)
67.
Advertisement
Table of Contents
