Table of Contents
Advertisement
Installation
5.4
Connecting to Serial RS232/RS485 Subnetwork
Use minimum 90 oC copper (Cu) wire only.
1.
Insert the cable wires into the 7-pin connector and tighten the wire clamp screws.
7-pin connector
2.
Connect the 7-pin connector to the Communicator.
3.
Connect the Communicator to your serial subnetwork.
To Do Next
Connect the Communicator to the Modbus TCP network and to power.
Check LED status, refer to
®
™
Anybus
Communicator
User Manual
Pin
1
2
3
4
5
6
7
Communicator LED Indicators, p.
Signal
+5 V OUT
RS485- A
RS485+ B
Signal GND
Functional Earth (FE)
RS232 Tx Output
RS232 Rx Input
87.
SCM-1202-162 1.1 en-US
19 (124)
Advertisement
Table of Contents
