Cable Replacement Mode Setup - HMS Networks Anybus Wireless Bolt II User Manual

Cable Replacement Mode Setup

5.5. Cable Replacement Mode Setup
Before You Begin
In a cable replacement installation, two Bolt II units are used.
One Bolt II acts as an access point and the other Bolt II acts as a client.
Procedure
Configure the Bolt II Cable Replacement Access Point
Figure 14. Configure the Bolt II Cable replacement access point
1. Connect the Bolt II access point to power.
2. Connect the Bolt II access point to your PC.
3. Login to the Bolt II access point built-in web interface.
4. Navigate to the Operation mode page.
5. Select the Cable replacement Device A Mode.
Figure 15. Select Cable replacement Device A
6. Navigate to the Wireless settings page.
SCM-1202-209 Version 1.0
® ™
Anybus Wireless Bolt II
Page 21 of 68