Table of Contents
Advertisement
Operations
3.
FPL
D
ENT
If the same waypoint appears in the approach
sequence more than once, be sure to turn to the
occurrence you wish to select.
4.
D
5.
6.
7.
Verify or select the next waypoint in
your flight plan. If the active waypoint is
not the one you wish to navigate to, select
a new active waypoint. If the active
waypoint you want is already in your
active flight plan, the easiest way to
select it is to press FPL, to enter flight
plan mode. Turn the Small knob until the
waypoint you want is shown as the "TO"
side of a flight plan leg (illustration).
Then press DIRECT-TO and ENT to
select the waypoint.
Note
Verify or select the course to the
waypoint. If a specific inbound course to
D
the active waypoint is to be intercepted
or flown, press DIRECT-TO twice.
Enter the desired the inbound course
with the Large and Small knobs. Then,
press ENT. Selecting an inbound course
in this manner will suspend flight plan
ENT
s e qu e n c i n g a n d t he O BS / HL D
annunciator will light.
If you do not wish to hold or execute a
procedure turn at the next waypoint, press
OBS/HLD to enable sequencing at the
active waypoint. You may also want to
manually select a flight plan leg to
intercept. In this case, press FPL, turn the
Small knob to the desired leg and press
ENT. Press ENT again to activate it.
After you have executed the missed
approach, you may want to proceed to
another destination or you may want to
execute the same approach or another
approach to the same airport.
Approach Procedures
255
Advertisement
Table of Contents
