Table of Contents
Advertisement
Navigation Information Sub-State
Changing the Oceanic Activation Altitude
The following procedure is used to set the altitude at which the NMC
will start and stop the Oceanic/Remote Flight Phase. The default
(factory) setting is 18000 feet. Acceptable settings are from 0 to 18000
feet in 100 foot increments.
1.
2.
ENT
3.
SEL
4.
194
In SYS mode, turn the Large knob to
display the Navigation Info page.
Press ENT to activate the Navigation Info
sub-state functions. Turn the Large knob to
display the Oceanic Altitude page.
Press SEL to activate editing.
Turn the Small knob to display the
ENT
desired activation altitude. The altitude
is changed in 100 foot increments. Press
ENT to save the setting.
Operations
SYS
SYS
Advertisement
Table of Contents
