Figure 22: Activation link on System Control Center home page
2. Use an Ethernet cable to connect the satellite modem to the customer's computer as shown in Figure 23: Ethernet
and other cables (final configuration) on page 43.
a) Disconnect the Ethernet cable from the installer laptop computer.
The Ethernet cable is already connected to the LAN port on the rear panel of the satellite modem.
b) Connect the Ethernet cable to the LAN port on the PC or other device as shown in Figure 23: Ethernet and other
cables (final configuration) on page 43.
Figure 23: Ethernet and other cables (final configuration)
HN9000 Satellite Modem Installation Guide
1037576-0001 Rev. A
Chapter 6
43