Operational And Safety Requirements For Canada; Repairs In Canada; Electromagnetic Interference (Emi); Fcc Part 15 - Hughes HughesNet HN9000 Installation Manual

Chapter 13

Operational and safety requirements for Canada

In addition to the warnings and safety guidelines listed in this document, the following operating conditions apply to
the modem when used in Canada:
The Canadian Department of Communications label identifies certified equipment. This certification means that the
equipment meets certain telecommunications network protective operational and safety requirements. The Department
does not guarantee that the equipment will operate to the user's satisfaction.
Before installing the equipment, users should make sure they are permitted connect to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of connection. In some
cases, the company's inside wiring associated with a single line individual service may be extended by means of a
certified connector assembly (telephone extension cord). The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.

Repairs in Canada

Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier.
Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines,
and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important
in rural areas.
Users should not attempt to make electrical ground connections themselves, but should contact the appropriate electrical
inspection authority, or electrician, as appropriate.

Electromagnetic interference (EMI)

This product conforms to EMI standards of the U.S. FCC and Canadian CSA. To ensure compliance with these standards,
installers and users must follow the installation, maintenance, and configuration procedures in the installation guide and
user guide.
This is a class B product. In a domestic environment this product may cause radio interference in which case the user
may be required to take adequate measures.

FCC Part 15

This section applies to the HN9000 satellite modem.
Standards to which Conformity is declared: FCC Part 15
The modem complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Responsible party's name: Hughes Network System, LLC
Address: 11717 Exploration Lane, Germantown, MD 20876
Telephone: 1 (866) 347-3292
Trade name: HUGHES
104
HN9000 Satellite Modem Installation Guide
1037576-0001 Rev. A