Routing Hydraulic Hoses And Electrical Components To M1240 Windrowers - MacDon R85 Operator's Manual

Routing Hydraulic Hoses and Electrical Components to M1240 Windrowers

To route the R85 Header hydraulic hoses and electrical harness to the M1240 Self-Propelled Windrower, follow
these steps.
1. Move windrower left-hand (cab-forward) platform (A)
to the OPEN position. For instructions, refer to the
windrower operator's manual.
2. Route the hose bundle (A) from the header, under
the windrower frame, then insert the pin (B) into the
hole (C) in the windrower frame.
NOTE:
Route hoses as straight as possible and
avoid rub/wear points that could damage the
hydraulic hoses.
3. Place hoses on support (D) and on the forming shield
hose support (not shown).
4. If your M1240 Windrower has factory-installed
quick connect couplers, refer to
Hydraulics Using Quick Couplers: M1240 Windrowers,
for connection instructions.
page 52
If your M1240 Windrower has factory-installed hard
plumb connections, refer to
Hydraulics Using Hard Plumbing: M1240 Windrowers,
for connection instructions.
page 53
214014
OPERATION
Connecting Header
Connecting Header
51
Figure 3.45: Windrower with LH Platform in
Open Position
Figure 3.46: Hydraulic Hoses
Revision B