Fcc Radiation Exposure Statement; Radio Frequency Interference Requirements - Meru Networks AP150 Installation Manual

USA

FCC Radiation Exposure Statement

Caution!

Radio Frequency Interference Requirements

Interference Statement
Note:
These devices comply with Part 15 of the FCC Rules. Operation of the devices is
subject to the following two conditions: (1) The devices may not cause harmful inter-
ference, and (2) The devices must accept any interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio frequency energy. If the
equipment is not installed and used in accordance with the instructions, the equip-
ment may cause harmful interference to radio communications. There is no guar-
antee, however, that such interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception
(which can be determined by turning the equipment off and on), the user is encour-
aged to try to correct the interference by taking one or more of the following
measures:
Relocate this device.
Increase the separation between the device and the receiver.
Connect the device into an outlet on a circuit different from that of other
electronics.
64 Meru Access Point and Radio Switch Installation Guide
The radiated output power of the Meru Networks, Inc. devices is well
below the FCC radio frequency exposure limits. However, the Meru Net-
works, Inc. Meru Access Points should be used in such a manner that the
potential for human contact during normal operation is minimized. To
avoid the possibility of exceeding the FCC radio frequency exposure limits,
you should keep a distance of at least 20 cm between you (or any other
person in the vicinity) and the Access Point antennas.
Meru Access Point
These devices are restricted to indoor use because they operate in the
5.15 to 5.25 GHz frequency range. The FCC requires such products to be
used indoors for the frequency range 5.15 GHz to 5.25 GHz to reduce the
potential for harmful interference to co-channel Mobile Satellite systems.
High-power radars are allocated as primary users of the 5.25 to 5.35 GHz
and 5.65 to 5.85 GHz bands. These radar stations can cause interference
with or damage to these devices, or both.
© 2007 Meru Networks, Inc.