Double Chamber - Vacuum Packaging Machines VC999 K12/K12N/K12A/K12NA
Operation
9.4.2
Switching on
NOTICE
The operations described in this section are based on the assumption that the operations
described in the previous section, "Operation" have been carried out!
Switch on the machine by turning the main switch from to 0 to I.
The program version no. is shown on both LED display 2.
Start the vacuum pump on the left-hand or right-hand controllers by pressing the „Vacuum pump"
key. When the vacuum chambers are closed, both vacuum chamber lids will swing upwards, and the
machine is ready for operation.
9.4.3
Inserting bags
Before you start the packaging process, program the appropriate packaging cycle. The section on
"Programming" describes how to compile a packaging program. If the requested program already exists,
proceed as follows:
Ensure that the vacuum chambers are clean and
dry before you start packaging.
Insert the bag, which is to be sealed, so that it lies
flat on the sealing pad.
Bags can be placed all along the sealing pads.
Make sure that the bags do not overlap!
Bag position without inert gas:
Do not allow the vacuum bag to protrude so far past
the sealing pad that it is trapped between the lid of the
vacuum chamber and the housing when the lid is
closed.
Bag position with inert gas:
Draw the vacuum bag over the inert gas nozzles, as
shown.
2013-12-17
Art. no. 520.454
Fig. 9/8
Fig. 9/9
Page 36/91