Nak Retries; Support Bel/Can In Ack/Nak - Honeywell Voyager 1200g User Manual

Communication Timeout Beeper
This selection programs the scanner to issue an error beep when a
communication timeout has occurred. The error beep sound is pro-
grammed using

NAK Retries

This selection limits the number of NAK retries that can occur in ACK/NAK
mode. Scan the bar code below, then set the number of retries (from 0-
255) by scanning digits from the
(5 is the recommended setting.) Default = 0, or disabled.

Support BEL/CAN in ACK/NAK

This protocol responds to <BEL> and <CAN> commands when in ACK/
NAK mode. The scanner sounds an error tone when a <BEL> command is
sent from the host. <CAN> terminates the transmission. Default = BEL/
CAN Off .
BEL/CAN On
2 - 8
Number of Beeps – Error
Programming
NAK Retries
(page 4-4). Default = On.
* On
Chart, then scanning Save.
* BEL/CAN Off