Programming The Measuring Point Switchover - Siemens SIPROCESS UV600 Manual

Holding the measured value
● If a measuring point is active, the measured values from it correspond to the current value
● While other measuring points are active, the measured value for this point is displayed as
Holding of the measured value also functions with analog outputs which output the value
from a measuring point.
7.5.11.1

Programming the measuring point switchover

Menu call:
Main menu → Parameters → Additional functions → Measuring point switchover → Measuring
points (MPi) → Measuring point
The following menu is displayed (example):
The parameters have the following meanings:
On/off
Name
Purging
time
Measuring
time
Status
Activate/deactivate measuring point
1. Use the
2. In the follow-up menu, use the
On
Off
SIPROCESS UV600
Operating Instructions, 10/2013, A5E03529375-02
of the gas analyzer following the purging time.
the constant value which was last measured at this point (hold amplifier function).
Activation status
Name of measuring point
Set purging time
Set measuring time
Digital output for status of output range
, and
following meanings apply:
This measuring point is used for the measuring point switchover
This measuring point is not used for the measuring point switchover
keys to select 'On/Off'
, and
Important functions (selection)
7.5 Parameter assignments
keys to set the desired state. The
153