Setting Limits - Siemens SIPROCESS UV600 Manual

7.5.6

Setting limits

Two limits for monitoring the measured value can be set for each measured component and
auxiliary value. The limit message can be triggered either with high or low violation of the
limit. It is also possible to set the switching hysteresis and the category to which the
message is to belong ("
Menu call:
Main menu → Parameters → Limits → [Measured component] → Limit [n]
The following menu is displayed (example):
You can then set the individual parameters as follows:
Setting a limit
Use the
Set the desired limit in the follow-up menu as described in section Character input (Page 64).
Selecting the message type
Use the
Set the message type in the follow-up menu using the
select from the following:
● (+) High violation
● (-) Low violation.
Hysteresis
Use the
Set the desired value in the follow-up menu as described in section Character input
(Page 64).
SIPROCESS UV600
Operating Instructions, 10/2013, A5E03529375-02
Signal type"
, and
, and
and
, and
{"Parameter";"Limit setting"}
).
keys to select the first parameter "Value".
keys to select the second parameter "Type".
keys to select the third parameter "Hysteresis".
Important functions (selection)
7.5 Parameter assignments
, and keys. You can
139