Siemens SIPROCESS UV600 Manual page 97

Setting the date of the next automatic calibration
The following menu is displayed following selection of the fourth parameter (4 Start date)
(example):
The previously set time is shown in line 2 and can be overwritten. Line 4 shows the display
format for the date and time input. Set the desired start date as described in section
Character input (Page 64). Switch to the follow-up menu for the time using the
Set the desired start date as described in section Character input (Page 64).
Input of the time parameters for the automatic calibration procedure or validation
measurement has then been completed.
SIPROCESS UV600
Operating Instructions, 10/2013, A5E03529375-02
Important functions (selection)
7.3 Calibration and validation functions
key.
97