Projector Body - Panasonic PT-EZ770 Series Operating Instructions Manual

Table of Contents

Advertisement

f Avoid contact with liquids or moisture.
f Do not attempt to modify or disassemble the remote control.
Note
f When operating the remote control by directly pointing the remote control signal receiver of the projector, operate the remote control at
a distance approx. 30 m (98'5") or shorter from the remote control signal receiver. The remote control can control at angles of up to ±30°
vertically and horizontally, but the effective control range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.
f The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material.
f If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly. Use
it in a place distant from the light source.
f The power indicator <ON (G)/STANDBY (R)> will flash if the projector receives a remote control signal.

Projector body

Front
1 2 3 4 5
6
7
Rear
9
10
11
12
Projection direction
WARNING
Keep your hands and other objects away from the air
exhaust port.
f Keep your hands and face away.
f Do not insert your fingers.
f Keep heat-sensitive objects away.
Heated air from the air exhaust port can cause burns, injury, or
deformations.
1
Remote control signal receiver (front)
2
Power indicator <ON (G)/STANDBY (R)>
Displays the status of the power.
3
Lamp indicator <LAMP>
You can display the status of the lamp.
4
Temperature indicator <TEMP>
Displays the status of the internal temperature.
5
Filter indicator <FILTER>
Displays the status of the air filter unit.
Chapter 1 Preparation — About your projector
8
6
13
14
15
Side
16
15
17
6
Adjustable feet
Adjusts the projection angle.
7
Speaker
8
Projection Lens
9
Air exhaust port
10 Remote control signal receiver (rear)
11 <MAIN POWER> switch
Turns off/on the main power.
12 <AC IN> terminal
Connect the supplied power cord.
13 Connecting terminals (x page 25)
14 Security slot
This security slot is compatible with the Kensington security
cables.
15 Air intake port
16 Air filter cover
The air filter unit is inside.
17 Control panel (x page 24)
9
ENGLISH - 23

Advertisement

Table of Contents
loading

Table of Contents