Table of Contents
Advertisement
Chapter 3 Basic Operations — Operating with the remote control
Note
f The hide condition of the on-screen display can also be canceled by pressing the <菜单> button on the control panel for at least three
seconds while the on-screen display is off (hidden).
Using the automatic setup function
The image position and the signal level can be automatically adjusted when HDMI/DisplayPort/DVI-D signal is
input.
It is recommended to input an image with bright white borders at the edges and high-contrast black and white
characters when executing the automatic setup. Avoid using images that include halftones or gradation, such as
photographs and computer graphics.
button
1)
Press the <自动设置> button.
f [COMPLETE] is displayed when it has completed without any problem.
Note
f The items to be automatically adjusted when the automatic setup function is executed can be set in the [DISPLAY OPTION] menu → [AUTO
SETUP] (x page 129).
f To input the DisplayPort/DVI-D signal directly to the projector without passing through the <DIGITAL LINK> terminal, it is necessary to install
the optional Interface Board equipped with the corresponding input in the slot.
f If an image with blurred edges or a dark image is input, [INCOMPLETE] may appear or the position adjustment may not be performed
properly even when [COMPLETE] appears. In such a case, adjust the following settings.
g The [POSITION] menu → [SHIFT] (x page 110)
f Automatic adjustment may not work depending on the model of the computer.
f Images may be disrupted for a few seconds during execution of the automatic setup, but it is not a malfunction.
f Adjustment is required for each input signal.
f Automatic setup can be canceled by pressing the <菜单> button while the automatic setup is being executed.
f Even if a signal possible to perform the automatic setup is being input, it may not be able to adjust correctly if the automatic setup function is
executed while the moving image is being input. [INCOMPLETE] may be displayed, or the adjustment may not be completed correctly even
if [COMPLETE] is displayed.
Switching the image aspect ratio
Switch the image aspect ratio according to the input.
button
1)
Press the <宽高比> button.
f The setting will change each time you press the button.
Note
f The aspect ratio of the image can also be switched using the menu operation. Refer to the [POSITION] menu → [ASPECT] (x page 110)
for details.
Using the function button
By assigning the following functions to the <功能> button, it can be used as a simplified shortcut button.
[SUB MEMORY], [SYSTEM SELECTOR], [SYSTEM DAYLIGHT VIEW], [FREEZE], [WAVEFORM MONITOR],
[LENS MEMORY LOAD], [PROJECTION METHOD], [GEOMETRY], [OSD POSITION]
button
1)
Press the <功能> button.
Note
f Assignment of the function is performed from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON] (x page 193).
The [FUNCTION BUTTON] screen can also be displayed by holding down the <功能> button on the remote control.
92 - ENGLISH
Advertisement
Table of Contents
