Table of Contents
Advertisement
Switching the projector on/off
Switching on the
projector
witching off the projector
Power indicator
Switch the MAIN POWER on.
• The power indicator lights up in
RED.
Remove the
Lens cover
from the lens
Press the POWER button,
• The power indicator lights up in
GREEN
after
flashing fora while.
The
STARTUP LOGO
is displayed on the
screen. See "STARTUP LOGO" on paqe 38.
NOTE;
--—-~
* ^ome ®mal1 rattlin9 or tinkling sound may be heard when starting up, but this is normal and does not affect
the performance of the projector.
w Do not attach anything on the
Lens cover
which may cause burns, fire or damage to the projector.
Power indicator
manpower
off
m
Press the POWER button.
• The confirmation screen is displayed.
• To return to the projection, press
ENTER
to
select
CANCEL
or press
MENU/RETURN.
2. Press ◄ to select OK and press POWER nr
ENTER.
• The power indicator lights up in
ORANGE
while
cooling the lamp, then illuminates
RED
when it
is ready to switch off the
MAIN POWER
3. Switch off the MAIN POWER on the
bark
nf
the projector.
NOTE;
• Press the
POWER
twice or for a long duration to switch the power.
Projecting an image
Positioning the image
Switch on the connected devices.
• Press the play button of the required device
Press the
INPUT
button to select the required
input method if needed. See "Switching the input
signal" on page 23.
• The image will be projected on the screen.
NOTE:
• AUTO SEARCH
is
ON
as default and the signal from the connected devices is detected automatically. See
"AUTO SEARCH" on page 38.
1. Press ASPECT to select the required aspect
mode. See "Switching the aspect ratio" on
page 23.
2. Adjust the projected image with the Lens
shift dials.
See "Lens shift and positioning"
on page 16.
4. Adjust the focus and the projected image
size.
• Press +/- of the
FOCUS
and
ZOOM
buttons to
adjust.
• Press the
LENS
button to adjust the focus and
zoom by Remote control, see "LENS
CONTROL Menu" on page 37
OPOWSR
.saw
3. Adjust the angle of the projector.
• Screw down the
Front
leg
adjuster
and adjust
the angle vertically.
NOTE;
• Do not touch the
Air
exhaust port as this may
cause burns or injury.
• If keystone distortion occurs, see "KEYSTONE'
on page 36.
Advertisement
Table of Contents
