Table of Contents
Advertisement
r PT-SMZ10KCL
[LIGHT OUTPUT] (%)
100.0
80.0
60.0
40.0
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu → [DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
Note
f The runtime may be shorter than the estimation due to the influence of characteristics of each light source, conditions of use, installation
environment, etc.
f If the runtime exceeds 20 000 hours, replacement of the components inside the projector may be required. Consult your dealer for details.
[LIGHT OUTPUT]
Adjust the brightness of light source.
The setting is reflected when it is already set with "Initial setting (operation setting)" (x page 54) in the [INITIAL
SETTING] screen or with the [PROJECTOR SETUP] menu → [OPERATION SETTING]. The [LIGHT OUTPUT]
setting is synchronized with the [PROJECTOR SETUP] menu → [OPERATION SETTING] → [LIGHT OUTPUT].
The most recent setting is reflected in both items.
1)
Press as to select [LIGHT OUTPUT].
2)
Press qw to adjust.
Operation
Press w.
Press q.
Note
f [LIGHT OUTPUT] can be adjusted individually for each setting item of [OPERATING MODE].
f The uniformity of the brightness between multiple screens can be maintained by adjusting [LIGHT OUTPUT] for each projector when
structuring a multi-display screen by combining the projected images from multiple projectors.
[STANDBY MODE]
Set the power consumption during standby.
1)
Press as to select [STANDBY MODE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[ECO]
[NORMAL]
Note
f When [ECO] is set, the network function, the <串口/多台投影机同步输出> terminal, and some RS-232C commands become inoperable
during standby. When [NORMAL] is set, the network function and the <串口/多台投影机同步输出> terminal can be used during standby.
f When [ECO] is set, it may take approximately 10 seconds longer before the projector starts projecting after the power is turned on,
compared with when [NORMAL] is set.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Brightness (lm)
100.0
90.0
80.0
70.0
60.0
50.0
40.0
30.0
20 000
21 000
22 000
Estimated runtime (hours)
Brightness
The screen becomes brighter.
The screen becomes darker.
Select this item to reduce power consumption during standby.
Select this item when using the network function during standby.
10 000
8 000
6 000
4 000
dust.
3
10 000
4 000
23 000
24 000
25 000
Adjustment
Runtime (estimate)
The runtime becomes shorter.
The runtime becomes longer.
Estimated runtime
(hours)
*1
20 000
21 500
23 000
25 000
Range of adjustment
8.0 % - 100.0 %
ENGLISH - 127
Advertisement
Table of Contents
