Table of Contents
Advertisement
Verifying Operation of ZS9-2 Slide-Rails and CMA
Note -
remove the latching bracket so that you can remove connector D.
11.
Gently tug on the four CMA connection points to ensure that the CMA
connectors are fully seated before you allow the CMA to hang by its own weight.
12.
Install and route cables to the controller, as required.
Verifying Operation of ZS9-2 Slide-Rails and CMA
Use the following procedure to verify the operation of the CMA and slide rails for a ZS9-2
controller.
Ensure all rack anti-tilt devices are extended to prevent the rack from tipping forward when the
Before You Begin
storage controller is extended from the rack.
1.
Slowly pull the storage controller out of the rack until the slide-rails reach their
stops.
Inspect the attached cables for any binding or kinks.
2.
3.
Verify that the CMA extends fully with the slide-rails.
128
Oracle ZFS Storage Appliance Installation Guide, Release OS8.8.x • August 2021
The slide-rail latching bracket has a green release tab. This tab is used to release and
Advertisement
Table of Contents
