Installing A Zs5-4 Controller; Installing The Slide Rails Onto A Zs5-4 - Oracle ZFS Installation Manual

Installing a ZS5-4 Controller

This section contains installation procedures for the ZS5-4 controller.
Before beginning installation, see
Overviews" on page
Use the following procedures to install a ZS5-4 controller:
"Installing the Slide Rails onto a ZS5-4" on page 147
■
"Installing the Slide Rails into the Rack for a ZS5-4" on page 148
■
"Installing a ZS5-4 onto the Rack Slide Rails" on page 150
■
"Installing a ZS5-4 Cable Management Arm" on page 152
■
"Verifying Operation of ZS5-4 Slide-Rails and CMA" on page 154
■

Installing the Slide Rails onto a ZS5-4

Use the following procedure to install the slide rails onto a ZS5-4 controller.
The slide rails can be used with either 9.5-mm square or M6 round mounting hole racks.
Note -
1. Position a mounting bracket against the chassis so that the slide-rail lock is at
the front of the chassis, and the five keyhole openings on the mounting bracket
are aligned with the five locating pins on the side of the chassis.
"Installation Prerequisites and Hardware
15.
Installing a ZS5-4 Controller 147