Secure Operation; Initial Set-Up; Fficer Guidance (First Use ) - Oracle StorageTek T10000D Manual

3 S O
ECURE PERATION
The Oracle StorageTek T10000D Tape Drive meets Level 1 requirements for
FIPS 140-2. This section provides Cryptographic Officer guidance for the proper
use and maintenance of the module. Instructions for placing the module into one
of the Approved modes are also provided. Operators of the ETD should read and
be familiar with the following Oracle documents prior to configuring and
operating the module:
 StorageTek T10000 Tape Drive Operator's Guide (Part#: E20714-08;
 Oracle Virtual Operator Pane 2.2: User's Guide (Part #: E55615-01;
 Oracle Key Manager: Administration Guide (Part #: E41579-05;
Prior to setting up the StorageTek T10000D Tape Drive for first use, the CO shall
use the instructions provided in these guides to install the latest versions of Oracle
Key Manager and the Virtual Operator Panel onto a trusted system. These
external software components are required for setting up the ETD for normal
operation.
3.1 Cryptographic Officer Guidance (First Use)
This section provides instructions on how to place the StorageTek T10000D Tape
Drive into each of the FIPS-Approved modes after first receiving the drive from
Oracle Corporation. For first-time use, these operations shall be performed with
an Oracle Service Representative present.

3.1.1 Initial Set-Up

Prior to placing the module into one of the Approved modes, the CO shall
perform the following steps:
1. Install the StorageTek T10000D Tape Drive following the instruction
provided in StorageTek T10000 Tape Drive Installation Manual
2. Examine the hardware part number on the rear label. Confirm it matches the
hardware version number on this Security Policy (Hardware Part #:
7042136/7314405)
3. Verify the VOP version is version 2.2 or higher.
4. Using VOP, the CO shall check the Version Tab (Retrieve View Drive
Data) to confirm the current firmware version number matches the firmware
version number listed on this Security Policy (Firmware Version: RB411111)
5. Using VOP, the CO shall check the Version Tab (Retrieve View Drive
Data) to confirm the version of the FPGAs
This document may be freely reproduced and distributed whole and intact including this Copyright notice.
June 2014)
August 2014)
September 2015)
a. CO Hardware Revision:
© Copyright 2017 Oracle Corporation
0000xxxxxxD7
Page 44 of 51