Table of Contents
Advertisement
4.
Raise the chassis so that the back ends of the mounting brackets are aligned
with the slide rail (1) and insert the chassis into the slide rails, pushing
the chassis slowly, until the mounting brackets meet the slide-rail stops
(approximately 12 inches, or 30 cm).
When inserting the controller into the slide rail, ensure that both the top and bottom
Caution -
mounting lips of the mounting brackets are inserted into the slide rail. The controller should
slide forward and backward easily if correctly installed. If the unit does not slide easily, ensure
that each mounting lip is inserted properly. If the mounting brackets are not inserted properly,
the unit may fall when removing it from the rack, causing equipment damage and possibly
personal injury.
5.
Simultaneously push and hold the green slide-rail release buttons on each
mounting bracket (2) while you push the chassis into the rack. Continue pushing
Installing a ZS7-2 onto the Rack Slide Rails
Installing a ZS7-2 Controller
135
Advertisement
Table of Contents
