1.
If your rack includes an anti-tip foot, extend it from the bottom of the rack.
Lower the rack stabilization feet if you have not already done so.
2.
Push the slide rails into the slide-rail assemblies in the rack as far as possible.
3.
Raise the chassis so that the back ends of the mounting brackets are aligned
4.
with the slide rail and insert the chassis into the slide rails, pushing the chassis
slowly, until the mounting brackets meet the slide-rail stops (approximately 12
inches, or 30 cm).
Installing a ZS4-4 or ZS3-4 onto the Rack Slide Rails
Installing a ZS4-4 or ZS3-4 Controller
179