Table of Contents
Advertisement
Installing a ZS7-2 Controller
This section contains installation procedures for the ZS7-2 controller.
Before beginning installation, see
Overviews" on page
Use the following procedures to install a ZS7-2 controller:
"Installing the Slide Rails onto a ZS7-2" on page 131
■
"Installing the Slide Rails into the Rack for a ZS7-2" on page 132
■
"Installing a ZS7-2 onto the Rack Slide Rails" on page 134
■
"Installing a ZS7-2 Cable Management Arm" on page 136
■
"Verifying Operation of ZS7-2 Slide-Rails and CMA" on page 144
■
Installing the Slide Rails onto a ZS7-2
Use the following procedure to install the slide rails onto a ZS7-2 controller.
The slide rails can be used with either 9.5-mm square or M6 round mounting hole racks.
Note -
1.
Position a mounting bracket against the chassis so that the slide-rail lock is at
the front of the chassis, and the five keyhole openings on the mounting bracket
are aligned with the five locating pins on the side of the chassis.
"Installation Prerequisites and Hardware
15.
Installing a ZS7-2 Controller
131
Advertisement
Table of Contents
