Table of Contents
Advertisement
enable
disable
get [prop]
set [prop]
hostname:maintenance system setup ntp> set servers=0.pool.ntp.org
hostname:maintenance system setup ntp> commit
hostname:maintenance system setup ntp> done
aksh: done with "ntp", advancing configuration to "directory" ...
Configure name services.
5.
For detailed information, see
Administration Guide, Release
Active Directory has two modes: domain and workgroup mode, which dictate how
Note -
SMB users are authenticated. In domain mode, SMB clients are authenticated through the
Active Directory domain controller, and you must ensure that the times on the appliance and the
domain controller match within five minutes.
NIS is an older directory protocol that is not very secure, and largely replaced by LDAP. It is
not recommended to run NIS and LDAP at the same time because they use the same domain
name setting.
Configure Name Services. Configure directory services for users and groups. You
can configure and enable each directory service independently, and you can
configure more than one directory service.
Subcommands that are valid in this context:
nis
ldap
ad
help [topic]
=> Enable the ntp service
=> Disable the ntp service
=> Get value for property [prop]. ("help properties"
for valid properties.) If [prop] is not specified,
returns values for all properties.
=> Set property [prop] to [value]. ("help properties"
for valid properties.) For properties taking list
values, [value] should be a comma-separated list of
values.
servers = 0.pool.ntp.org (uncommitted)
"Configuring Services" in Oracle ZFS Storage Appliance
OS8.8.x.
=> Configure NIS
=> Configure LDAP
=> Configure Active Directory
=> Get context-sensitive help. If [topic] is specified,
Performing Initial Configuration (CLI)
Configuring the Appliance for the First Time
261
Advertisement
Table of Contents
