Table of Contents
Advertisement
Powering Off a Controller
The controller automatically powers on.
3.
Wait until the Power/OK LED on the front panel next to the Power button lights
and remains lit (approximately two minutes).
If the Service Required amber indicator is lit, see
Faults" in Oracle ZFS Storage Appliance Customer Service
documentation located in the documentation library for this software release at
oracle.com/en/storage/.
Related Topics
"Powering Off a Controller" on page 234
■
Powering Off a Controller
The recommended methods for powering off a controller depend on whether you have
completed initial configuration. Use a power off method from one of the following two
situations.
If you have completed initial configuration, power off the controller using one of the following
methods:
Log in to the BUI and click the power icon
■
SSH in to the appliance and enter the maintenance system poweroff command.
■
Use a pen or non-conducting pointed object to press and release the Power button on the
■
front panel.
If you have not completed the initial configuration steps, power off the controller using one of
the following methods:
Use a pen or non-conducting pointed object to press and release the Power button on the
■
front panel.
SSH or use a serial connection to log in to the service processor (SP), and then issue the
■
command stop /SYS.
To initiate an emergency shutdown during which all applications and files will be closed
■
abruptly without saving, press and hold the Power button for at least four seconds until the
Power/OK status indicator on the front panel flashes, indicating that the storage controller is
in standby power mode. To completely remove power, disconnect the AC power cords from
the rear panel of the storage controller.
Related Topics
234
Oracle ZFS Storage Appliance Installation Guide, Release OS8.8.x • August 2021
"Using Oracle ILOM to Diagnose Hardware
Manual. Also see the Oracle ILOM
on the left side under the masthead.
http://docs.
Advertisement
Table of Contents
