Table of Contents
Advertisement
Installing the Switch on a Wood Wall
This section contains instructions on how to install the switch on a wood
stud in a wall.
Here are the tools and material required for installing the switch on a wall
with wooden studs:
Two wall brackets (included with the switch)
Four bracket screws (included with the switch)
Cross-head screwdriver (not provided)
Stud finder capable of identifying the middle of wood wall studs and
hot electrical wiring (not provided)
Four wall screws for attaching the switch to the wall. The diameter
of the screw holes in the wall brackets is 4.5 mm (0.17 in.).
To install the switch on a wall, perform the following procedure:
1. Install the two wall brackets to the back panel of the switch, with the
four screws included with the unit. Refer to Figure 21.
Figure 21. Installing the Wall Brackets on the Switch
2. Use a stud finder to identify and mark the middle of a wood stud in the
wall at the location where you want to install the switch.
IE200 Series Installation Guide
65
Advertisement
Table of Contents
