Table of Contents
Advertisement
ATTACHMENTS AND OPTIONS
Change the working mode and enter the Attachment Mode.
1.
Press the working mode selector switch (1).
The screen changes to the working mode selection
screen.
2.
Press the working mode selector switch (1) or switch F3 or
F4 to select the Attachment Mode ATT/P or ATT/E.
3.
With the Attachment Mode ATT/P or ATT/E highlighted in
yellow, do one of the following to enter the selection.
1)
Hold down the working mode selector switch (1).
2)
Leave as it is for 10 seconds.
3)
Press the switch F6.
REMARK
•
Even if P, E, or L mode is selected, the attachment is
not operated.
•
Page feeding can be done by pressing the switches
F1 and F2.
•
(A) shows the flow rate which flows through the at-
tachment and (B) shows the hydraulic oil pressure
which flows through the attachment.
For the hydraulic oil pressure through the attachment,
consult your Komatsu distributor.
METHOD FOR OPERATION WHEN USING GENERAL ATTACHMENT 1 (E.G.
CRUSHER)
When operating the attachment using rolling switch, lock the pedal with the lock pin to avoid accidental
operation.
1. Proportional Control Rolling Switch
HANDLE MACHINE READY FOR INSTALLATION OF ATTACHMENT
k
k
WARNING
6-51
Advertisement
Table of Contents
