HANDLE MACHINE READY FOR INSTALLATION OF ATTACHMENT
2.
Place the attachment on a horizontal place, install pin (A)
and then pin (B) in this order to the arm.
3.
Lower the attachment to the ground and stop the engine.
4.
Turn the starting switch to ON (B) position.
5.
Set the lock lever to FREE position (F).
6.
Operate each work equipment control lever and attach-
ment control pedal fully to the front, rear, right, and left a
few times within 15 seconds to release the internal pres-
sure in the hydraulic circuit.
6-46
ATTACHMENTS AND OPTIONS