Table of Contents
Advertisement
OPERATION
8.
Turn auto-deceleration switch (7) OFF and operate the fuel
control dial to set the engine to low speed.
Each time auto-deceleration switch (7) is pressed, it
switches OFF to ON to OFF in turn.
When auto-deceleration switch (7) is turned OFF, the auto-
deceleration pilot lamp (8) goes out.
9.
Raise the work equipment and move slowly.
10. When the machine is horizontal on the top of the rear end
of the trailer, stop the machine.
11. Set the angle between the arm and boom to 90 to 110 °.
NOTICE
When unloading the machine, always set the angle be-
tween the arm and boom to 90 to 110 °.
If the machine is unloaded while the arm is IN, it will
cause damage to the machine.
12. Lower the bucket to the ground.
NOTICE
Do not hit the bucket against the ground to prevent
damage to the hydraulic cylinders.
13. With the bucket lowered to the ground, move to the ramps
slowly from the rear end of the trailer.
14. Operate the boom and arm slowly to lower the machine
carefully until it is completely off the ramps.
TRANSPORTATION
3-259
Advertisement
Table of Contents
