MACHINE OPERATIONS AND CONTROLS
Adjust the mirror so that the side of the machine is reflect-
ed in the mirror as shown in the figure.
PROCEDURE FOR ADJUSTING MACHINE RIGHT FRONT MIRROR (B)
(PC210-11, PC210LC-11)
To prevent the machine from moving during the work, make sure that the following conditions are met
before starting the work.
•
The machine is placed on a firm, level ground.
•
The work equipment is lowered to the ground in secure posture.
•
The lock lever is in LOCK position.
•
The engine is stopped.
Adjust the mirror so that you can see a person at the rear right
of the machine.
1.
Adjust the mirror with your hand so that the side of the ma-
chine is reflected in the mirror as shown in the figure.
2.
Check that you can see a person at the rear right of the
machine, at a height of 1.2 m and a distance of 1.0 m from
the machine.
3.
If you cannot adjust, loosen mounting bolts (1) and (2) of
the mirror and stay, and adjust the angles.
Tightening torque of mounting bolt (1): 6.0 to 7.0 Nm {0.61
to 0.71 kgm}
Tightening torque of mounting bolt (2): 6.0 to 7.0 Nm {0.61
to 0.71 kgm}
3-164
k
k
CAUTION
OPERATION