Table of Contents
Advertisement
OPERATION
3.
Open fuel filler cap (F) on the fuel tank and add fuel
through the filler port until float gauge (G) comes up to the
highest point.
Fuel tank capacity: 400 ℓ
Position of tip (a) of float gauge (G) when fuel tank is full:
Approximately 50 mm
REMARK
If breather hole (3) in the cap is clogged, the pressure in-
side the tank will go down and this may cause the fuel to
stop flowing. To prevent this, clean the breather hole from
time to time.
4.
After adding fuel, push float gauge (G) straight down with
fuel filler cap (F). Be careful not to get float gauge (G)
caught in the tab (2) of fuel filler cap (F), and tighten fuel
filler cap (F) securely.
METHOD FOR CHECKING DEF LEVEL, ADDING DEF (PC210-11, PC210LC-11)
•
Do not put fluid other than DEF into DEF tank.
•
When opening the cap of DEF tank of the machine, the ammonia vapour may escape. Keep your
face away from the filler port.
•
Foreign materials in the DEF system or urea deposits caused by precipitation of urea may hinder
operation of the devices. Before removing the filler cap, wipe off the dirt from around the filler port.
Before inserting the filler nozzle into the filler port, wipe off dirt from it.
•
If DEF is spilled, immediately wipe and wash the area with water. If spilled DEF is left unattended
and the area is not wiped and cleaned, it can cause corrosion to the contaminated area and emit
toxic gas.
MACHINE OPERATIONS AND CONTROLS
k
k
WARNING
3-151
Advertisement
Table of Contents
